IC PROGRAMMER

Product Details:

Description: The PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE) and it does this all at a most affordable price point. It can program a large range of PIC chips, including the PIC10F, 12F, 16F, PIC18F, 24F/H, dsPIC and PIC32 (future) families. Additionally it is firmware upgradeable, and Microchip regularly releases new firmware to support new PIC chips.
Logic Power PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer. In-circuit debugging offers these benefits:

• Low cost
• Minimum of additional hardware needed for debug
• Expensive sockets or adapters are not required

• USB (Full speed 12 Mbits/s interface to host PC)
• Real-time execution
• MPLAB IDE compatible (free copy included)
• Built-in over-voltage/short circuit monitor
• Firmware upgradeable from PC/web download
• Totally enclosed
• Supports low voltage to 2.0 volts (2.0v to 6.0v range)
• Diagnostic LEDs (power, busy, error)
• Read/write program and data memory of microcontroller
• Erase of program memory space with verification
• Freeze-peripherals at breakpoint
• Program up to 512K byte flash with the Programmer-to-Go

Product Details:

Product Details:

• Support Win2000, WinXP, Win2003, WinVista, Win7(32bit and 64bit) operating system.
• Original creation: Support AVR MCU internal RC Calibration to operate on Encrypted volume of chips
• Support 12700+ Chips, support serial series, parallel series chips, thousands of 40/44/48 Pin high capacity Flash
• Best internal 40 pins overvoltage protection, the best VPP, VCC 4th grade overcurrent protection.
• Short circuit won't reset PC or programmer.